So I’m sure none of you are surprised to hear that I’ve been asked a bunch about support for the Raspberry Pi 3 B+ in Fedora. Well the good news is that it’ll be supported in Fedora 28. Most of the bits were there for the official Fedora 28 beta, it just needed a minor work around, but nightly images since Beta have had all the bits integrated so the upcoming Fedora 28 GA release will support the Raspberry Pi 3 B+ to the same levels as the original 3 B on both ARMv7 and aarch64. The Fedora Raspberry Pi FAQ has now been updated with all the details of both the RPi3+ and Fedora 28.

WiFi

As with the original 3 there’s files with the firmware we can’t redistribute. The details are documented in the Fedora Raspberry Pi FAQ.

You can grab the files like for the 3 although there’s now an extra one, which you don’t really need, but it gives you all the 802.11a frequencies:

$ sudo curl https://fedora.roving-it.com/brcmfmac43455-sdio.txt -o /lib/firmware/brcm/brcmfmac43455-sdio.txt
$ sudo curl https://fedora.roving-it.com/brcmfmac43455-sdio.clm_blob -o /lib/firmware/brcm/brcmfmac43455-sdio.clm_blob

I’ve also done a rpm of the files for both editions of the RPi3 (plus a few other brcm adapters used on ARM boards). You can either just grab the rpm or setup the repo if you want to get the latest if I update it:

$ sudo curl https://fedora.roving-it.com/wireless.repo -o /etc/yum.repos.d//wireless.repo
$ sudo dnf install brcm-firmware

Issues

Like all new things there’s often a few teething problems. Over all the support for the new RPi 3 B+ is relatively solid but like all new devices there’s some bits still bedding down, and the combination of a new device and new OS there’s been a few minor issues that have been seen in some circumstances. We pulled in the latest firmware just before GA to fix some issues but no doubt as it gets wider testing both in Fedora and in the wider Raspberry Pi community more issues may well come up.

The ones we’re aware of are:

• The new USB hub and gigbit ethernet interface have seen a few issues in some cases. We’ve pulled in quite a few patches to help stabilise the NIC in Linux and it now mostly works in the vast majority of use cases.
• The USB hub in u-boot, uEFI and grub on aarch64 can cause some issues. If there’s too many USB devices connected it sometimes won’t boot or will do so really slowly. The work around for the moment is to disconnect all the USB devices until Fedora has started to boot and then plug them in.

In Fedora we’ll deliver updates and fixes by the usual updates, in particular as fixes land upstream we’ll review and land them where useful into Fedora, more than likely via a kernel update. If you see a uboot-tools or a bcm283x-firmware update you’ll want to run the rpi-firmware-update command to update the firmware and then reboot for it to take effect.

Older releases

We won’t be supported the new device in the older releases. Why I hear you say? Well it’s possible but it needs update to the firmware, U-Boot and kernel to work. The Raspberry Pi foundation respun Raspbian to support it and basically it’s not straight forward. Much better to have a new shiny Fedora for a new shiny device!